Standard FRP DN25 1.5mm Osmosis Water Softener For Softing Water

4000L Per Hour Flow Water Softner For Softning Water RO Machine

Water Softener

Water quality is good

Due to the counter-current regeneration process, the resin regeneration is quite thorough, and the impurities remaining on the upper end of the filter will also be washed out, greatly improving the effect of soft water.

Salt consumption is low

According to the structure of the filter layer, more calcium (Ca+) and magnesium (Mg+) ions are absorbed by the resin in the front section. During regeneration, the regeneration liquid penetrates from the bottom to the top.
The sodium (Na+) ions in the resin at the bottom also flow to the upper layer, which in turn generates rapidly in a chain reaction, greatly improving the efficiency.

This can reduce the waste of regenerated liquid, and therefore reduce the wastage of regenerated salt.
According to the actual data measurement, the salt consumption of reverse-current regeneration is 30%-50% lower than that of downstream regeneration softener.

Low water consumption

The reverse flow regeneration rate used in the automatic water softener is low, and the upper layer containing the most calcium and magnesium ions can be flushed out of the equipment first.

This minimizes the waste of water.

And equipped with flow valve to ensure resin in the adsorption of saturated regeneration, to avoid waste of resources.

High resin regeneration

Based on the actual measurement of the bottom resin regenerated by the prusize technology, the regeneration degree can reach more than 90%, while the downstream regeneration is only about 30%-50%. In this way, more water can be softened after each regeneration, which greatly saves the operation cost.